A2 LED Display Pocket & Ceiling-to-Floor Kit (Ready to Use / Complete System)

A2 LED Display Pocket & Ceiling-to-Floor Kits are available with portrait & landscape panels; A2 standard size. Dual-sided acrylic holders allow 2 posters to be inserted into a single pocket, enabling adverts to be displayed inward & outward-facing in your window display! Pocket insert size: 420mm x 594mm. The cable display system features chrome fittings and 1.5mm steel cables, 4m in length.

Complete A2 Display LED Pocket Kits - include:

• LED A2 Pockets, Portrait or Landscape (up to 3 Holders per kit)
• LED Driver / Transformer & 5m electrical wiring with 3 pin plug (UK)
• 2x Power Connectors
• 2x Ceiling to Floor Cable Display System Sets, including 4m Steel Cable
• Display Pocket Supports, 4 per Panel (Attach Pockets to Suspended Cables)

Installing the Cable Display System:

1. Seperate a ceiling fitting, by unscrewing the brass screw mounts concealed inside
2. Screw the brass mount into the ceiling, and reattach the ceiling fittings shell & cable
3. With the cable now suspended, align the position for the floor fitting
4. Un-screw & seperate the floor fitting, and screw the wider/bottom half into the floor
5. Thread the cable into 1 Power Connector, the floor fitting top, and finally the tension spring, in that order
6. Attach the Brass Stopper to the end of the cable, and cut away any unwanted extra cable
7. Rettach the floor fittings top to the bottom piece
8. Repeat above steps for the second ceiling to floor cable (Use an LED pocket's width as a guide!)
9. Attach your LED Display Pockets to the suspended cables, using the Supports provided (Allen / Hex Key Supplied)

Although this is a safe low-voltage product, please remember to UNPLUG & SWITCH OFF any power while installing!

Installing LED Driver / Transformer:

1. Attach a naked-end wire to one of the Power Connector on a suspended cable
2. Secure the Power Connector by tightening the small grub-screw on the relevant side
3. Attach the other wire to the Power Connector of the opposite cable
4. Secure the Power Connector to the wire
5. Finally plug the transformer into the power socket